Module 02 — Estimating · Module 03 — Standards · Module 04 — Defensibility
Restoration Estimating Engine™
Standards-aware estimating for mitigation, mold, fire/smoke, and rebuild. Every line item is linked to the evidence and the standard that justifies it. Click any item to see the forensic basis on the right — and the missing documentation, if any.
Carrier estimate — address pending extraction
Estimate (RCV)$29,500.00
Estimate · standards-justified scope
All 11
Mitigation 6
Mold remediation 1
Demolition 2
Structural drying 2
Rebuild & finish 0
Contents 0
RCV
$29,500.00
11 line items
Recoverable depreciation
—
—
Defensibility
52%
avg confidence
Missing evidence
0 items
all linked
Mitigation
$29,500.00Crawl Space Stabilization & Access PreparationStabilize crawl space conditions to allow for safe access and workability during mitigation activities, which may include removal of saturated or compromised soil as needed. Installation of entry and exit containment at crawl space access points may be performed as required to control debris, airflow, and cross-contamination during work.
—
—
$0.00
Crawl Space Water ExtractionExtract standing water from crawl space to establish initial working conditions. May include adjustment or temporary relocation of sump pump/discharge components to improve water management during mitigation.
—
—
$0.00
Crawl Space Debris Removal & Cleaning PreparationRemove debris, contaminated materials, and loose contents as needed and properly dispose of materials in accordance with applicable regulations. Detach and reset HVAC ducting, piping, and other utilities as required to allow for proper access to affected materials and completion of mitigation activities. Final extent to be determined based on-site conditions.
—
—
$0.00
HEPA Vacuuming & Surface CleaningPerform HEPA vacuuming and surface cleaning of accessible structural components prior to antimicrobial treatment.
—
—
$0.00
Evaluation of Structural Materials (As Needed)Evaluate exposed structural components, including exterior wall sheathing and framing, for moisture-related damage following material removal.
—
—
$0.00
CRAWL SPACE MITIGATION – Total Lump SumProjected Mitigation Cost Range (Based on Observed Conditions): Estimated project cost is anticipated to fall within the range of $25,000 – $29,500, based on current site conditions and typical drying timelines. Final cost will be determined by actual site conditions encountered during mitigation.
1 LS
$29,500.00
$29,500.00
Mold remediation
$0.00Microbial Treatment – Structural Framing & SurfacesApply antimicrobial treatment to exposed crawl space surfaces, including floor framing, joist cavities, wall framing, and foundation walls following completion of drying and cleaning activities.
—
—
$0.00
Demolition
$0.00Selective Demolition of Non-Salvageable Materials (As Needed)Remove and dispose of saturated, contaminated, and non-salvageable materials from the crawl space as encountered, including but not limited to insulation at ceiling and accessible wall areas, insulation associated with HVAC ducting, piping, and other insulated lines, as well as selective demolition of additional affected materials as required to allow for proper access, drying, and remediation. Final extent to be determined upon exposure.
—
—
$0.00
Remove Existing Vapor BarrierRemove and dispose of existing vapor barrier to allow access to underlying soils and structural components.
—
—
$0.00
Structural drying
$0.00Drying Equipment Setup (Air Movers, Dehumidification & Air Scrubbers)Provide temporary power distribution as needed, including installation of spider boxes and extension of circuits to support operation of drying equipment. Install and operate drying equipment, including air movers, dehumidifiers, and air scrubbers, to reduce moisture levels and improve environmental control within the crawl space. Utilize air scrubbers and airflow management as needed to control airborne particulates and improve air quality during mitigation and remediation activities.
—
—
$0.00
Moisture Monitoring & Equipment AdjustmentsMonitor moisture levels and adjust drying equipment as needed to support effective drying throughout the mitigation process. Remove drying equipment, including air movers and dehumidifiers once acceptable drying conditions and moisture standards have been achieved.
—
—
$0.00
Reminder: All scope, pricing, and standards mappings are recommendations based on uploaded evidence. VVON™ does not guarantee carrier approval and is not a substitute for licensed professional judgment.
Scope is fully linked. No supplement is warranted at the current scope state.